Replace the rubber ring, reinstall, and when installing the hose joint, it is not advisable to use too much force, which will cause damage to the leather pad of the water pipe

Remove the faucet faucet and replace it with an aerator

The faucet still comes out of the water after the spool is closed. The solution is to remove the handle and decorative cover, re-tighten the pressure cap, and there is a possibility that the rubber ring at the bottom of the valve core is deformed and cannot seal the water, the solution is to take out the valve core, check the rubber ring at the bottom, and reinstall it after resetting.

See if the water from other adjacent faucets is also very small, if it is also very small, it is a problem with the water pressure of the tap water. If the water pressure is insufficient, it is recommended to add an electric water pump; b. If the waterway is blocked or the aerator is blocked, and there is rust or impurities, the valve core can be removed and the waterway can be flushed; If it's just the aerator clogged, just remove the aerator and clean it; c. If the sewer is slow and the sewer is blocked, use dredging agent or use physical negative pressure to dredge; It is also possible that the sewer is too thin and not matched.

In the process of installation, you should first put the faucet on the joint of the inner wire without winding the raw material belt, to see if there is a problem with the inner wire on the street, and find that the faucet is installed straight, and then remove it and re-wrap the raw material belt